等厚双层涂层材料受集中力作用的平面问题理论解

界面应力的正确评价是分析薄膜涂层材料力学特性的难题之一。利用镜像点法和Dirichlet等值性原理，本文推导了等厚双层薄膜涂层材料受表面集中力作用的平面问题理论解。该显式理论解是以固定在各镜像点上的局部坐标系下的Goursat应力函数的形式给出的。对应于高阶镜像点的应力函数，可通过递推的方法，从对应于低阶镜像点的应力函数求得，而且也易于计算机编程。随着镜像点阶数的增大，它与界面的距离也越来越大，因而相对应的应力函数对界面应力的影响越来越小。最后的算例表明，只需考虑前面有限个镜像点，便可获得足够精度的解。该理论解可作为格林函数，以求解复杂问题的理论解，也可用作边界元法的基本解，提高数值计算的精度和效率。     

Thickness decrease of a grafted polyelectrolyte membrane exposed to shear flow

The effect of the shear flow on the thickness change of a polyelectrolyte membrane grafted onto a glass substrate was directly investigated with a flow cell combined with a confocal laser scanning microscope. The membrane thickness decreased proportionally to an increase in the shear stress of the flow when the shear rate exceeded a critical value of 1 s^?1. The higher the ionic strength was of the fluid, the greater the thinning effect was. The correlation between the critical shear rate and the relaxation of the polymer in the gel membrane was examined. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 2808–2815, 2003     

Stress Tensor Fluctuations and Passive Quantum Gravity

The quantum fluctuations of the stress tensor of a quantum field are discussed, as are the resulting space-time metric fluctuations. Passive quantum gravity is an approximation in which gravity is not directly quantized, but fluctuations of the space-time geometry are driven by stress tensor fluctuations. We discuss a decomposition of the stress tensor correlation function into three parts, and consider the physical implications of each part. The operational significance of metric fluctuations and the possible limits of validity of semiclassical gravity are discussed.     

Anomalies of attenuation and phase velocity of surface acoustic waves in YBa2Cu3O7‒δ thin films in the vicinity of Tc

We present measurements of the attenuation and phase velocity of surface acoustic waves in thin YBa₂Cu₃O films as a function of temperature, in magnetic fields up to 3.6 T applied parallel to the c-axis of the films. We have observed anomalies in both, the attenuation and the phase velocity in the vicinity of the superconducting critical temperature which do not depend on the magnetic field. Possible origins of these anomalies, observed, to our knowledge, for the first time in YBa₂Cu₃O thin films, are discussed and compared to bulk acoustic wave experiments. We present a kind of feedback technique for surface acoustic waves which improves the sensitivity of this type of measurement. The actual sensitivity limits are mentioned. Received: 7 August 1997 / Revised: 7 November 1997 / Accepted: 17 November 1997     

Order and chaos in soft condensed matter

Soft matter, like colloidal suspensions and surfactant gels, exhibit strong response to modest external perturbations. This paper reviews our recent experiments on the nonlinear flow behaviour of surfactant worm-like micellar gels. A rich dynamic behaviour exhibiting regular, quasi-periodic, intermittency and chaos is observed. In particular, we have shown experimentally that the route to chaos is via Type-II intermittency in shear thinning worm-like micellar solution of cetyltrimethylammonium tosylate where the strength of flow-concentration coupling is tuned by the addition of sodium chloride. A Poincaré first return map of the time series and the probability distribution of laminar length between burst events show that our data are consistent with Type-II intermittency. The existence of a ‘Butterfly’ intensity pattern in small angle light scattering (SALS) measurements performed simultaneously with the rheological measurements confirms the coupling of flow to concentration fluctuations in the system under study. The scattered depolarised intensity in SALS, sensitive to orientational order fluctuations, shows the same time-dependence (like intermittency) as that of shear stress.     

An accurate method to predict the stress concentration in composite laminates with a circular hole under tensile loading

The paper presents a theoretical-numerical hybrid method for determining the stresses distribution in composite laminates containing a circular hole and subjected to uniaxial tensile loading. The method is based upon an appropriate corrective function allowing a simple and rapid evaluation of stress distributions in a generic plate of finite width with a hole based on the theoretical stresses distribution in an infinite plate with the same hole geometry and material. In order to verify the accuracy of the method proposed, various numerical and experimental tests have been performed by considering different laminate lay-ups; in particular, the experimental results have shown that a combined use of the method proposed and the well-know point-stress criterion leads to reliable strength predictions for GFRP or CFRP laminates with a circular hole. Russian translation published in Mekhanika Kompozitnykh Materialov, Vol. 43, No. 4, pp. 531–570, July–August, 2007.     

葛仙米对丁草胺胁迫的响应

研究了丁草胺对可食用蓝藻葛仙米(Nostoc sphaeroides)生理和代谢活性的影响．用不同浓度的丁草胺处理葛仙米,结果显示低浓度(5 mg·L-1)丁草胺使其光合作用、呼吸作用和光合系统Ⅱ活性增强,高浓度丁草胺(>5 mg·L-1)限制其光合作用、呼吸作用和光合系统Ⅱ活性．同时丁草胺对葛仙米膜结构和功能具有破坏作用,随着丁草胺处理浓度增大,质膜透性不断增大,丙二醛和超氧自由基阴离子含量升高；在低浓度丁草胺处理时,类胡萝卜素含量增加,超氧化物歧化酶(SOD)活性增强,高浓度丁草胺处理时,类胡萝卜素含量降低,SOD活性下降；表明葛仙米对低浓度的丁草胺胁迫具有一定的耐受能力,但高浓度的丁草胺对其生理和代谢构成威胁；针对目前葛仙米野生生境中丁草胺的用量,建议限制丁草胺在葛仙米产地的使用,以保护日益稀缺的葛仙米资源．     

The stress driven instability in elastic crystals: Mathematical models and physical manifestations

Summary Equilibrium equations and stability conditions for the simple deformable elastic body are derived by means of considering a minimum of the static energy principle. The energy is supposed to be sum of the volume (elastic) and the surface terms. The ability to change relative positions of different material particles is taken into account, and appropriate natural definitions of the first and second variations of the energy are introduced and calculated explicitly. Considering the case of negligible magnitude of the surface tension, we establish that an equilibrium state of a nonhydrostatically stressed simple elastic body (of any physically reasonable elastic energy potential and of any symmetry) possessing any small smooth part of free surface is always unstable with respect to relative transfer of the material particles along the surface. Surface tension suppresses the mentioned instability with respect to sufficiently short disturbances of the boundary surface and thus can probably provide local smoothness of the equilibrium shape of the crystal. We derive explicit formulas for critical wavelength for the simplest models of the internal and surface energies and for the simplest equilibrium configurations. We also formulate the simplest problem of mathematical physics, revealing peculiarities and difficulties of the problem of equilibrium shape of elastic crystals, and discuss possible manifestations of the above-mentioned instability in the problems of crystal growth, materials science, fracture, physical chemistry, and low-temperature physics.     

Properties of ITO films prepared by reactive magnetron sputtering

Indium tin oxide (ITO) thin films were deposited by mid frequency pulsed dual magnetron sputtering using a metallic alloy target with 10 wt.% tin in an atmosphere of argon and oxygen. The aim of the work was to study the interdependence of structural, electrical and optical properties of ITO films deposited in the reactive and transition target mode, respectively. The deposition rate in the transition mode exceeds the deposition rate in the reactive mode by a factor of six, a maximum value of 100 nm·m min⁻¹ could be achieved. This corresponds to a static deposition rate of 200 nm min⁻¹. The lowest electrical resistivity of 1.1·10⁻³ Ω cm was measured at samples deposited in the high oxygen flow range in the transition mode. The samples show a good transparency in the visible range corresponding to extinction coefficients being below 10⁻². X-ray diffraction was used to characterise crystalline structure as well as film stress. ITO films prepared in the transition mode show a slightly preferred orientation in (211) direction, whereas films deposited in the reactive mode are strongly (222) oriented. Compared to undoped In₂O₃ all samples have an enlarged lattice. The lattice strain perpendicular to the surface is about 0.8% and 2.0% for films grown in the transition and the reactive mode, respectively. Deposition in the transition mode introduces a biaxial film stress in the range of −300 MPa, while stress in reactive mode samples is −1500 MPa.     

Magnetic phase transitions in nanostructures induced by shear stress under high pressure

Magnetic phase transitions of the first and second order were revealed by Mössbauer spectroscopy in nanosystems of - and -ferric oxides and metallic europium subjected to shear stress (240°) under high pressure (20 kbar). For - and -ferric oxide nanoclusters, the Curie (Neel) points decreased to 300 K, whereas for nanostructured europium the Neel point increased from 90 to 100 K. The thermodynamic model of magnetic phase transitions predicting a change in the character of magnetic phase transitions and a decrease (increase) in the critical Neel (Curie) points in nanoclusters was developed. The type of magnetic phase transitions and the change in the critical points were caused by defects in nanoclusters, whose maximum concentration was observed for the clusters with the 20—50 nm size range.